GTH-C3 Customer Documentation

GTH-C3 Hardware Getting Started Guides

Safety information, connector pinouts and a Declaration of R&TTE conformance. Every GTH-C3 system includes a hard copy of this document when delivered.

10-0013: E1/T1 Monitor 3.0
10-0014: SDH Monitor 3.0

GTH-C3 Software Getting Started Guide

Describes how to use the built-in WWW server on the GTH module to configure a new GTH module.

10-0002: Getting Started Guide (Software)

GTH-C3 Hardware Certification and Regulatory Testing

GTH-C3 hardware has been tested by Intertek Testing (ETL-SEMKO).

These documents are available to our customers. If you want a password, contact

Reports for GTH 3.0 and STH 3.0 hardware

IEC 62368-1 Test Report (2017)
IEC 62368-1 CB Certificate (2017)
UL 62368-1/CSA C22.2 62368-1 Recognized Component Report (2017)
EN 300 386 EMC Test Report (2011) GTH 3.0  STH 3.0 
FCC Part 15 EMC Test Report (2011) GTH 3.0  STH 3.0

Documents for superseded hardware

Test reports for GTH 2.1 systems. GTH 2.1 was superseded by GTH 3.0 in 2014.

- 10-0006: E1/T1 Messenger 2.1 Getting started
IEC/EN 60950-1 Test Report (2011)
IEC/EN 60950-1 CB Certificate (2013)
ANSI/UL 60950-1 CAN/CSA-C22.2 No. 60950-1 Recognised Component Report (2013)
EN 300 386 EMC Test Report (2006)
FCC Part 68 Test Report (2006)
CS03 ISDN Test Report (2006)

Test reports for GTH 2.0 systems. GTH 2.0 was superseded by GTH 2.1 in 2008.

IEC/EN 60950-1 Test Report
Recognized Component Report
CB Certificate

Safety information and pin-outs for GTH 1.x and IEB 1.0 systems. GTH 1.x and IEB 1.0 systems were superseded by GTH 2.0 in 2006.

GTH 1.x/IEB 1.0
CB Certificate for GTH 1.x(2004)
EMC Test Report for GTH 1.x
EN 60950 Electrical Safety Test Report for GTH 1.x
EN 60950 Verification of Conformity for GTH 1.x